N6003
Compostable thermoplastic composite material is suitable for injection moulding.
SKU: N6003
| Weight | 1 kg |
|---|---|
| Moulding Process | Injection Moulding, Thermoforming, Blow Film |
| Tensile Strength (MPA) | 23 |
| Flexural Modulus (MPA) | 500 |
| Elongation (%) | 450% |
| Notched Impact (KJ / M^2) | 48 |
| Mold Shrinkage (%) | 0.20% |
| Density (g/cm^3) | 1.28 |
| MFI (g/10min @ 190C / 2.16kg) | 6 |
| Carbon Emission (Kg CO2 / Kg) | 0.78 |
| Renewable Content (%) | 60 |
| Recycled Content (%) | 0 |
| Certificates | Food Contact Safe |
| General Instructions | The material is delivered in the form of pellets/granules. It must be stored dry, in sealed containers, and be protected from direct sunlight. Refer to our processing guide before using the material. |
| General Disclaimer | In spite of our best efforts, the actual colour & properties of the moulded products may vary due to the natural fibers & changes in processing conditions. It is safe to assume 10% factor of safety in properties while engineering new products, & any colour variations need to be addressed at the time of moulding. For regulatory compliance, it is recommended to get your product certified based on the regions where they are intended to be used or sold. This information is a computer generated. It is true to the best of our knowledge. We make no warranty, expressed or implied regarding the performance or otherwise. |
| Weight | 1 kg |
|---|---|
| Moulding Process | Injection Moulding, Thermoforming, Blow Film |
| Tensile Strength (MPA) | 23 |
| Flexural Modulus (MPA) | 500 |
| Elongation (%) | 450% |
| Notched Impact (KJ / M^2) | 48 |
| Mold Shrinkage (%) | 0.20% |
| Density (g/cm^3) | 1.28 |
| MFI (g/10min @ 190C / 2.16kg) | 6 |
| Carbon Emission (Kg CO2 / Kg) | 0.78 |
| Renewable Content (%) | 60 |
| Recycled Content (%) | 0 |
| Certificates | Food Contact Safe |
| General Instructions | The material is delivered in the form of pellets/granules. It must be stored dry, in sealed containers, and be protected from direct sunlight. Refer to our processing guide before using the material. |
| General Disclaimer | In spite of our best efforts, the actual colour & properties of the moulded products may vary due to the natural fibers & changes in processing conditions. It is safe to assume 10% factor of safety in properties while engineering new products, & any colour variations need to be addressed at the time of moulding. For regulatory compliance, it is recommended to get your product certified based on the regions where they are intended to be used or sold. This information is a computer generated. It is true to the best of our knowledge. We make no warranty, expressed or implied regarding the performance or otherwise. |